Steering Wheel

Description

Home built steering wheel for the commodore 64/128.

The steering wheel was taken from an unidentified wreck found in the woods around 1985. My best guess so far is that it was a 1960 BMW Isetta. At least it looks exactly like that one and from what I remember it was a very small wreck indeed.

A ball-bearing was put on the wheel axis to hold it in place in a wooden frame. The frame could then be fastened to a table with clamps.

Further down the axis was a small wheel which drove a multi-turn potentiometer. The pot was then directly connected to the ADC of one of the Commodores joystick ports.

Sewing machine foot pedals were used for the accelerator and breaks, again directly connected to the Commodore ADCs.

Condition

The wooden frame is falling apart. The steer can be turned if handled with care. The pot is not connected anymore. But all parts are still there.

Software

Test Drive was adapted to make use of the steering wheel and accelerator pedal.

But the floppy that holds the only copy I have is physically damaged. The disk surface looks good but the inner ring is folded. The disk can only be inserted with the B side facing up. Using the 1571 drive of the C128 it should be possible to read both sides to restore the contents.